50 lines
2.2 KiB
Plaintext
50 lines
2.2 KiB
Plaintext
# Configuration for the preserve-files job
|
|
#
|
|
# The *files* key contains a list of files to preserve. Each element of
|
|
# the list should have one of these forms:
|
|
#
|
|
# - an absolute path (probably within the host system). This will be preserved
|
|
# as the same path within the target system (chroot). If, globally, dontChroot
|
|
# is true, then these items are ignored (since the destination is the same
|
|
# as the source).
|
|
# - a map with a *dest* key. The *dest* value is a path interpreted in the
|
|
# target system (if dontChroot is true, in the host system). Relative paths
|
|
# are not recommended. There are three possible other keys in the map:
|
|
# - *from*, which must have one of the values, below; it is used to
|
|
# preserve files whose pathname is known to Calamares internally.
|
|
# - *src*, to refer to a path interpreted in the host system. Relative
|
|
# paths are not recommended, and are interpreted relative to where
|
|
# Calamares is being run.
|
|
# - *perm*, is a colon-separated tuple of <user>:<group>:<mode>
|
|
# where <mode> is in octal (e.g. 4777 for wide-open, 0400 for read-only
|
|
# by owner). If set, the file's ownership and permissions are set to
|
|
# those values within the target system; if not set, no permissions
|
|
# are changed.
|
|
# Only one of the two source keys (either *from* or *src*) may be set.
|
|
#
|
|
# The target filename is modified as follows:
|
|
# - `@@ROOT@@` is replaced by the path to the target root (may be /)
|
|
# - `@@USER@@` is replaced by the username entered by on the user
|
|
# page (may be empty, for instance if no user page is enabled)
|
|
#
|
|
# Special values for the key *from* are:
|
|
# - *log*, for the complete log file (up to the moment the preservefiles
|
|
# module is run),
|
|
# - *config*, for the Calamares configuration file
|
|
# - *globals*, for a JSON dump of the contents of global storage
|
|
---
|
|
files:
|
|
- /etc/oem-information
|
|
- from: log
|
|
dest: /root/install.log
|
|
perm: root:wheel:644
|
|
- from: config
|
|
dest: /root/install.cfg
|
|
perm: root:wheel:400
|
|
|
|
# The *perm* key contains a default value to apply to all files listed
|
|
# above that do not have a *perm* key of their own. If not set,
|
|
# root:root:0400 (highly restrictive) is used.
|
|
#
|
|
# perm: "root:root:0400"
|