calamares-settings/calamares/modules/preservefiles.conf
davedatum ee58b2457b #
2019-10-28 13:54:52 +00:00

50 lines
2.2 KiB
Plaintext

# Configuration for the preserve-files job
#
# The *files* key contains a list of files to preserve. Each element of
# the list should have one of these forms:
#
# - an absolute path (probably within the host system). This will be preserved
# as the same path within the target system (chroot). If, globally, dontChroot
# is true, then these items are ignored (since the destination is the same
# as the source).
# - a map with a *dest* key. The *dest* value is a path interpreted in the
# target system (if dontChroot is true, in the host system). Relative paths
# are not recommended. There are three possible other keys in the map:
# - *from*, which must have one of the values, below; it is used to
# preserve files whose pathname is known to Calamares internally.
# - *src*, to refer to a path interpreted in the host system. Relative
# paths are not recommended, and are interpreted relative to where
# Calamares is being run.
# - *perm*, is a colon-separated tuple of <user>:<group>:<mode>
# where <mode> is in octal (e.g. 4777 for wide-open, 0400 for read-only
# by owner). If set, the file's ownership and permissions are set to
# those values within the target system; if not set, no permissions
# are changed.
# Only one of the two source keys (either *from* or *src*) may be set.
#
# The target filename is modified as follows:
# - `@@ROOT@@` is replaced by the path to the target root (may be /)
# - `@@USER@@` is replaced by the username entered by on the user
# page (may be empty, for instance if no user page is enabled)
#
# Special values for the key *from* are:
# - *log*, for the complete log file (up to the moment the preservefiles
# module is run),
# - *config*, for the Calamares configuration file
# - *globals*, for a JSON dump of the contents of global storage
---
files:
- /etc/oem-information
- from: log
dest: /root/install.log
perm: root:wheel:644
- from: config
dest: /root/install.cfg
perm: root:wheel:400
# The *perm* key contains a default value to apply to all files listed
# above that do not have a *perm* key of their own. If not set,
# root:root:0400 (highly restrictive) is used.
#
# perm: "root:root:0400"